NOTE:
Press the “AUTO TUNE” button for the best reception. Should you experience any frequency interference, move your channel switch from one channel to the other channel (there are two channels for selection) on the transmitter, and then press the “AUTO TUNE” button again.
5.When the batteries are installed, your speakers are portable and can be carried freely from room to room (and outdoors) up to their maximum range of 150 ft.. Should you encounter any sound disruption (signal cuts off or carries distortion), press the speaker’s “AUTO TUNE” button to maximize the best reception.
If you hear interference from the components, switch on the channel control of transmitter, and then move the speakers to another location. You can
When transmitting/receiving over long distances, the signal from the system will become weaker. This system will transmit through walls, floors and other obstacles However, range will be maximized by the “line of sight” placement with no obstacles between the transmitter and the speakers. Keep this in mind when placing your equipment throughout your house.
Page 6
6.To put unit in Standby Mode:
a)To protect the transmitter and save power, the transmitter will turn off automatically if it detects that the unit is not being operated or, there is weak reception from the signal audio source, for 5 minutes. In other words, if the signal comes back, the transmitter will work again automatically
b)To put the speakers in Standby mode, press the power button on the remote control unit. The LED light will change from Blue to Green.
c)You can take the speakers out of Standby mode by pressing the power button on the remote control unit. If the speakers remain in Standby mode, after 5 minutes they will automatically power off.
ATTENTION:
The transmitter for this speaker set is designed to work with a variety of devices. Our tests have shown the default volume levels of iPods, MP3 players and other devices connected to the transmitter through the headphone jack does not have the signal strength required by the transmitter. Raising the volume of your device will increase the signal strength to the receiver. The blue signal LED will light when the required signal strength from your device is reached. We recommend that you keep the volume set on your iPod or MP3 player at a minimum of ¾ of full volume.
To Turn Speakers Off
1)Press ON/OFF button on individual speakers.
2)Put in Standby mode using remote control unit – will shut off automatically within 5 minutes.
3)Unplug media unit – will shut off automatically within 5 minutes.
WARNING
The AC/DC power adapters are for indoor use only. For all weather use, please use “C” alkaline batteries (not included) in each speaker.
This device must be used with the AC/DC adapters supplied in the package.
Page 7
