4.Press On/Off button located on each speaker and turn the speakers ON. The POWER LED will light up in Blue. To turn the speakers off, press the ON/OFF button located on the speakers and the POWER LED will turn off.*
5.To suit the needs of different users, these speakers are designed for optional wall mounting. There are two holes at the back of each speaker so that they can be hung easily on the wall.
*NOTE: Remote control unit does not turn speakers ON. Keep speakers within reach.
REMOTE CONTROL UNIT
1.Remove the battery cover at the rear of the remote control unit and insert 2 “AAA” batteries (not included) into the battery compartment with correct polarity
2.Replace the cover and close the battery compartment.
3.Remote can be used to:
-Adjust volume
-Auto tune
-Put speakers into and out of Standby mode – after 5 minutes, Speakers will automatically power off.
*NOTE: Remote control unit does not POWER ON Speakers.
Page 4
CONNECTING TO MEDIA DEVICE
The rear of the transmitter has one audio cord that can be connected properly to the audio output jack of TV, Computer, VCR, Radio, CD/MP3/VCD/DVD/Blu- Ray players or to headphone/earphone jack with the connector provided.
Note: You may need the included iPhone Adapter to connect your iPhone to the transmitter for audio streaming. Simply plug the cable from the transmitter into one end of this Phone Adapter, and then plug the other end of the adapter into your iPhone.
When the transmitter receives an audio signal, the blue SIGNAL LED and the red POWER LED will illuminate together. If the blue SIGNAL LED does not illuminate, ensure that the audio source is turned on.
If the blue light on the transmitter doesn’t light up, ensure audio source is turned on and select “AUTO TUNE” on remote control unit or speakers.
OPERATION
1.Turn on the audio source (TV or audio component) to which the transmitter is connected with. The blue signal LED on the transmitter will light up.
2.Select the channel (1 or 2) of the transmitter for best performance in your location.
3.Turn on the ON/OFF button on the speakers (the Power button on the remote control unit cannot be used to switch on the speakers). Press the “AUTO TUNE” button to get the best tuning reception in the speakers. When the button is pressed, frequency tuning starts automatically and it stops when a signal is detected. Tuning process can also be activated by pressing the “AUTO TUNE” button on the
remote control unit.
4.Volume can be adjusted up by pressing the “+” button or down by pressing the
Page 5
