Kodak ESP 7 manual Connecting to an unlisted network, Key/Passphrase Description Security String

Setting Up Your Printer

Key/Passphrase/	Description
Security String
	5 or 13 ASCI characters; case-insensitive
WEP Key	or
	10 or a 26 Hexidecimal digits; case-insensitive.
WPA /WPA2 phrase	8-63 printable ASCI; case-sensitive characters.

8After completing your entry, select the DONE key, and then press OK.

LED Status	Description
Fully Lit	When lit, signals that a wireless (Wi-Fi) network
	connection has authenticated to the router, but
	your connection may not be active. You can
	verify the connection through the Network
	Settings menu.

Blinks when

•searching for an available Wi-Fi network within range

•existing signal is too weak to transmit

Blinking

The LED has a repetitive cycle of blinking, then resting for 15 seconds, followed by blinking again. The Wi-Fi radio will continue to attempt connection to the network until a connection is established.

The LED will be continuously lit when you are connected to a wireless network. This does not guarantee you are connected. You must verify that you are connected. See “Verifying network configuration” on page 30.

Connecting to an unlisted network

1Wi-Fi Setup Wizard is the first option; press OK to select it.

2If your network does not appear in the list and is configured to not broadcast its SSID, select Unlisted Network and press OK.

3Follow the prompts to enter the network name using the keyboard visible on the LCD

screen. Press , , or to select a key. Enter the alphanumeric string accurately,

using the same upper and lower case letters as your SSID. After completing your entry, select DONE, and then press OK.

4Select WEP or WPA/WPA2 as required for your network's security setup, and then press

OK.

5Enter the security information required using the LCD screen keyboard.

• Press , , or to select a key. Select <BKSP to erase any incorrect characters. Then select DONE and press OK.

28 Kodak ESP 7 Printer User Guide