Kodak ESP 7 manual No TCP/IP, Printer not found

Chapter 9

Bottom light This yellow light flashes when data is being sent or received by the device over the network.

To establish an active network connection

1Check the cable connections from the All-in-One printer to your gateway, router, or hub to ensure connections are secure.

2If the connections are secure, turn off the power on the All-in-One printer, and then turn it on again. Press the On/Off button on the control panel to turn the printer off, and press it again to turn it back on. Also, turn off the power on your router or hub, and then turn it on again.

No TCP/IP

Probable Cause

Your Local Area Network (LAN) card is not installed properly.

Corrective Action

Make sure your LAN card is installed properly and set up for TCP/IP. See the instructions that came with your LAN card.

Printer not found

Probable Cause 1

The All-in-One printer is not turned on.

Corrective Action

Turn on the printer.

Probable Cause 2

You do not have an active network connection.

Corrective Action

Make sure you have an active network connection.

To make sure your network connection is active

1If the connections are secure, turn off the power on the All-in-One printer, and then turn it on again. Press the On/Off button on the control panel to turn the printer off, and press it again to turn it back on. Also, turn off the power on your router or hub, and then turn it on again.

2Check the cable connections from the printer to your gateway, router, or hub to ensure connections are secure.

3Make sure the printer is connected to the network with a CAT-5 or better Ethernet cable.

Kodak ESP 7 Printer User Guide 87