Refer to the operating manual of your balanced-output line-level source to verify that the pin assignments of its output connector correspond to the Nº28. If not, wire the cable so that the appropriate output pin connects to the equivalent input pin.

Note: If you won't be using the Nº28's balanced inputs and need more single-ended inputs, it's possible to fabricate a cable to connect line-level sources with single-ended output to these balanced inputs:

Male RCA (connect to source)

1

22-guage buss wire

 

 

Male XLR

3

2

(connect to

 

Nº28)

6TAPE 1, TAPE 2 (OUTPUTS)

Connect these outputs to the right-channel and left-channel tape inputs of your tape machine.

These outputs are unaffected by the OUTPUT LEVEL control on the front panel of the Nº28.

7MAIN

Connect these outputs to the right-channel and left-channel inputs of your power amplifier or electronic crossover.

These outputs are affected by the OUTPUT LEVEL control on the front panel of the Nº28.

8BALANCED MAIN

If your power amplifier is equipped with balanced input connectors, it's best to connect it to the Nº28 via these connectors, particularly if long cable lengths are required.

Connect the right-channel and left-channel BALANCED MAIN outputs of the Nº28 to the appropriate balanced inputs of the power amplifier.

The pin assignments of these XLR-type male outputs are:

Pin 1: Signal ground

1 2 Pin 2: Signal + (non-inverting)

3Pin 3: Signal – (inverting)

Connector ground lug: chassis ground

Refer to your power amplifier's operating manual to verify that the pin assignments of its input connector correspond to the Nº28. If not, wire the cable so that the appropriate output pin connects to the equivalent input pin.

3

Page 8
Image 8
Mark Levinson N28 manual Tape 1, Tape 2 Outputs