Marmitek MEGACAM4 user manual Installing the Camera

Setting for channel 1

5.Transmitter and receiver have to be set to the same channel. If the camera suffers from interference, you can set it to a different channel.

6.Switch on the receiver by pressing the ON/OFF switch (1).

7.Switch your TV channel to the AV input (number 0 or AV/Scart).

8.You can now watch the camera images on your TV.

9.The channel indicator (3) will blink once, twice, three or four times to indicate which channel it is set to (Channel 1 = once, Channel 2 = twice, etc.).

6. INSTALLING THE CAMERA

The range of the camera and the receiver is dependent on the local situation, but usually somewhere between 15 and 30 m.

The camera is splash-waterproof, according to the IP44 norm. The camera is allowed to get wet, but hard jets of water or heavy rain can enter the camera and cause damage. The camera should be mounted in a sheltered spot (under the eaves, porch etc.).

The signal from the camera can travel through walls and ceilings. The route the signal travels, is not a straight line. Any time the signals go through walls, ceilings and other obstacles, the signal will bend. This can mean that by slightly moving the camera (sometimes just a few centimetres) you can greatly improve the reception. We advise you to first check where you can get optimal range, before fixing the camera in place.

First attach the wall bracket, and then place the camera. Drill a hole through the wall to connect the camera to the power adapter. The plug connecting the camera with the power adapter should preferably be placed on the inside.

THE POWER ADAPTER SHOULD ALWAYS BE PLACED INSIDE.

GIGACAM 4 7