Marquis DVR-38, DVT-38 FAN & V ALVE WIRING DIAGRAM/INSTRUCTIONS

Marquis 38 17
FAN & VALVE WIRING DIAGRAM/INSTRUCTIONS
ELECTRICAL CONNECTIONS (for optional convection fan kit FK 36/38 only)
• Install the fan first. Remove the lower louvers and gently place the bottom front lip of the blower
mounting bracket into the opening. Slide the blower assembly into the bottom of the fireplace.
Rotate the blower into position. Be careful not to damage the fan blades. The fan blades will now
face towards you. Line up the holes on fan bracket to the mounting bracket at the bottom of the
fireplace. Place a screw at each of the three holes and tighten.
• Run 120VAC power line through the left side of the fireplace and into the bottom of the gas
fireplace.
• Be sure to connect a grounding wire to the side of gas fireplace. Use any screw hole on the side
for this purpose.
• Slide the thermal snap switch into the fork like bracket underneath the left side of the firebox.
• Neatly tie down and tuck the wires down at the bottom and to the back of the fireplace.
• CAUTION: Do not allow any wires to touch the bottom of the firebox. Otherwise, the wires will
melt and short-out.
• Screw the speed controller bracket to the bottom left sidewall of the gas fireplace.
VALVE CONNECTIONS
SPEED CONTROL
LINE CONVECTION FAN
GROUND
110F (43ºC) N.O.
THERMAL SNAP SWITCH
NEUTRAL TO
APPLIANCE
120 VAC
WIRING DIAGRAM
OPTIONAL
REMOTE SWITCH
OPTIONAL
THERMOSTAT
SWITCH
TO SPARKER
PILOT
ASSEMBLY
THERMOPILE
SPARK ELECTRODE
THERMOCOUPLE
PILOT
BURNER
300F N.C.
SPILLAGE
SWITCH