MG50FX / MG100FX
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 |
Rear panel shows MG50FX combo - MG100FX combo has the same features
MG100HFX head is identical except features two loudspeaker sockets
Technical Specifications
MG50FX Combo
Power (RMS) | 50W |
Channels | 4 |
Speaker | 1x12" |
Weight (kg) | 16.6kg |
Size (mm) W, H, D | 518 x494 x278 |
MG100FX 1X12" Combo (MG101FX)
Power (RMS) | 100W |
Channels | 4 |
Speaker | 1x12" |
Weight (kg) | 20kg |
Size (mm) W, H, D | 591 x528 x283 |
MG100FX 2x12" Combo (MG102FX)
Power (RMS) | 100W |
Channels | 4 |
Speaker | 2x12" |
Weight (kg) | 22.4kg |
Size (mm) W, H, D | 674 x494 x278 |
MG100HFX Head
ENGLISH
21
1. Input Jack Socket
Jack input for your guitar. Use a good quality guitar cable (i.e. one that’s screened/shielded) to help prevent noise, interference and unwanted feedback.
2. Gain Control
Controls the amount of signal entering the
3. Clean : Crunch Switch
Selects between Clean (green) and Crunch (red) channels.
4. Bass Control
Adds warmth and
5. OD Switch
Selects between OD1 (green) and OD2 (red) channels.
6. Middle Control
Varies the amount of body in your sound.
7. Treble Control
Increasing the Treble will make your sounds brighter and more cutting, turning it down will decrease your tone’s edge and make it sound softer as a result.
8. Rev Switch
Switches the reverb effect on and off.
9. Reverb Control
This control lets you add a lush reverb to the selected channel, from a subtle hint to cavernous and all points
10. Volume Control
Controls the volume of the selected channel.
22 | 23 | 24 | 25 | 26 |
11. FX Switch |
|
|
|
|
Switches the FX section (Modulation and Delay) on and |
|
|
| |
off. |
|
|
|
|
12. Mod Control |
|
|
|
|
Selects and adjusts one of three modulation effects |
| 19. Store Switch | ||
Chorus, Phaser & Flanger. |
|
| ||
13. Tap Switch |
|
| Stores the current amp settings into the current channel | |
Matches the delay FX time to the time between two |
| or into the footcontroller. When in manual mode the | ||
pushes. The LED flashes at selected delay time. |
| Store button lights red. | ||
14. Delay Control |
|
| 20. Power Switch | |
Controls the amount of signal sent to the delay effect. |
| The power switch turns your amplifier on and off. A | ||
| channel switch will light up when your amplifier is turned | |||
15. Ext FX Switch |
|
| on and none will be lit when the amplifier is switched off. | |
Switches the external FX Loop on and off. |
| Please ensure the amplifier is switched off and unplugged | ||
16. Master Control |
|
| from the mains electricity supply before being moved. | |
Controls the master volume of the amplifier. |
| 21. Mains Input Connector | ||
17. Damping (Manual) Switch |
|
| Your amp is provided with a detachable mains (power) | |
Switches the power amp damping between classic amp |
| lead, which is connected here. The specific mains input | ||
feeling (LED off) and modern response (LED on). |
| voltage rating that your amplifier has been built for is | ||
Holding down the Damping switch for longer than 2 |
| indicated on the back panel. Before connecting for the | ||
seconds switches the amp between manual and preset |
| first time, please ensure that your amplifier is | ||
mode (page 6). |
|
| compatible with your electricity supply. If you have any | |
|
| doubt, please get advice from a qualified technician. | ||
When using the footcontroller, holding both the |
| Your Marshall dealer will help you in this respect. | ||
Damping switch and the Store switch will activate the |
| The correct value of mains fuse located in the small | ||
tuner. |
|
| ||
|
| drawer at the bottom of the mains socket is specified on | ||
18. Headphones / Line Out Socket |
| the rear panel of the amplifier. The drawer contains a | ||
3.5mm headphones / Line out. |
|
| space for a spare fuse. NEVER attempt to bypass the | |
|
|
| fuse or fit one of the incorrect value! | |
Power (RMS) | 100W |
Channels | 4 |
Speaker | - |
Weight (kg) | 11.4kg |
Size (mm) W, H, D | 591 x249 x275 |
22. Footcontroller Socket
Jack socket for the connection of the footcontroller.
23. Loudspeaker Output(s) Socket
The MG50FX, MG100FX combos have 1 loudspeaker output and the MG100HFX head has 2 loudspeaker outputs.
Always use a
24. MP3 Line In Socket
Jam to your favourite MP3, CD or tape track by connecting the line out or headphone output of your player here. Adjust the volume of your player to match that of your guitar and you’ve got the perfect ‘play- along’ practice system.
25. Return Socket
Connect to the output of an external effects processor or pedal here.
26. Send Socket
Connect to the input of an external effects processor or pedal here.
4 | 5 |
