Marshall electronic 6-00518-02 instruction sheet Marshall, V-R573P Instruction Sheet

Marshall	V-R573P Instruction Sheet
Broadcast Multimedia Division	http://www.LCDRacks.com e-mail: sales@mars-cam.com

The V-R573Pis a rack mounted unit that has three independently controlled 5.7” active matrix LCD panels with loop-through capability. This unit also has a unique feature that allows the unit to tilt up or down for optimum viewing angle. The unit fits into a EIA standard 19” rack, three rack spaces high. Each of the three screens has individual front mounted selector buttons with LED’s and color, tint, brightness and contrast controls. Each screen has two composite video NTSC/PAL inputs with loop- through and a built-in color bar generator.

The operation of the V-R573P is fairly straight forward. However, it is important to take note of the following:

1.Each LCD Panel comes with a protective plastic film that must be removed by carefully lifting the film from the corner and peeling it off. Be certain not to apply any pressure on the LCD panels, they are fragile and can break. Scratched, cracked or broken LCD screens are not covered by our warranty.

2.The V-R573P uses 12VDC, 2.0amp regulated power. Be certain that these specifications are met when using a power supply other than the one supplied to you by Marshall Electronics.

3.The polarity configuration for the V-R573P is indicated on the rear panel of the unit. Any battery operation of the V-R573P must have this polarity configuration.

4.The video inputs on the rear of the panel are 75 Ohm self-terminated. The loop-through feature uses active components and is always active as long as power is supplied to the unit regardless of the monitor being ON or OFF.

Rear View Side View

Display	Active Area	Dot Pitch	Picture	Inputs	Color	Dimensions	Power
			Elements		Bars		Consumption
5.7" LCD	115.2mm x	0.18mm x	640 x 480			18.96W x	12 VDC 2.0
	86.2mm Per			2 Composite	Built In
Active Matrix		0.18mm	Per Panel			5.2H x 2.5D	Amps
	Panel