Martin Fireplaces VFCS30SPV manual Electrical Wiring Milli-Volt, Operating Thermostat Sensor, page

	ELECTRICAL WIRING (MILLI-VOLT)
4. Remove adhesive backing from plastic clip. Press	Valve
clip to bottom of valve. Clip thermo bulb into plastic
clip. See Figure 13.

5. Reattach faceplate or reinstall base.

6.Install knob to shaft of t-stat sensor. See Figure 13,

page 17.

Thermo

Bulb

Plastic Clip

Figure 13 - Clipping Thermo Bulb into

Plastic Clip.

OPERATING THERMOSTAT SENSOR

1.Follow millivolt lighting instructions on lighting plate attached to unit or in homeownerʼs manual.

2.With control knob in the “ON” position make sure the ON/OFF switch is in the “OFF” position. See Figure 16.

3.The unit is now being controlled by the thermostat sensor. The sensor will now cycle the burners on and off. You can adjust how often the unit cycles by turning the control knob on the sensor.

REMOTE CONTROL

PILOT

Piezo

Ignitor Hi/Lo

Knob

Pilot

OFF

Optional

Fan

Figure 16 - Control Knob in “ON” Position and ON/OFF Switch in “OFF” Position

58D6003 17