MOUNTING THE SCRIPT

Unpack the Script speakers with brackets attached and the accessory kit. You should find:

2 ea. - Script speaker with bracket

4 ea. - wall anchors

4 ea. - #8 x 1 inch Phillips head screw 4 ea. - #12 black flat washers

4 ea. - 5/8 inch fiber washers

2 ea. - knob

2 ea. - knob with 1/4 inch - 1 inch stud 2 ea. - power cord (AC)

4 ea. - 1-1/2inch diameter spacer

WARNING! Installing the Script on a wall requires only 1 person, but an assistant can be helpful.

NOTE: To assure that your Scripts are safely wall mounted, these instructions must be carefully followed. Study them thoroughly before beginning to install your Scripts.

NOTE: The following instructions assume the mounting surface is of standard wood frame and standard sheet rock construction. If you wish to mount the Script to another type of material, you should consult a bonded contractor.

The functional Script wall bracket is designed to mount the Script securely to your wall and allows the Script to pivot on a nearly 180 degree axis for maximum versatility.

Before you begin to install your Scripts on a wall, prepare a work area—either on a carpeted floor or on a sturdy tabletop covered by a soft blanket or other cloth to prevent damaging the speaker cabinet.

The Wall Mount Bracket

The functional Script wall bracket is designed to hold the Script securely to your wall and allows the Script to swing on a nearly 180 degree vertical axis for maximum versatility.

Preparing for Installation

1The Script is shipped with the wall bracket mounted on and positioned to the side of the speaker cabinet, pro- tected by micro-foam packing material. Set the Script on its side with the bracket facing up. Loosen the knob on the bottom and the knob on the top. Swing the bracket down until the bracket is nearly parallel to the back of the Script (see figure 2, step A).

2Loosen and remove the knob on the bottom of the speaker—notice that the 5/8 inch fiber washer and 1-1/2inch diameter rubber spacer are shipped installed. The fiber washer will come free when you remove the wing nut—set the washer aside. Loosen and remove the knob on top of the bracket while holding the bracket with your free hand—set the fiber washer and 1-1/2inch rub- ber spacer aside (see figure 2, step B).

3Carefully pivot the top of the wall bracket away from the Script until the wall bracket clears the top of the speaker cabinet (see figure 2, step C). Next, move the bracket down to free it from the threaded stud projecting from the bottom of the speaker cabinet. Make sure that the 1-1/2inch spacer remains on the projecting threaded stud (see figure 2, step D). Finally, remove the micro-foam packing material.

Figure 2.

6 Mounting the Script