Figure 7.

8Position a black rubber spacer over the threaded hole in the top of the speaker cabinet and carefully pivot the top of the Script into the wall bracket. Carefully move the speaker cabinet so that the center of the rubber spacer, the top-support hole, and the threaded hole on top of the Script cabinet are aligned. You may find it helpful to secure the rubber spacer over top of the wall brackets top support hole with loosely applied masking tape that you can easily remove once the knob is in place. Insert the male threaded knob through a fiber washer, the wall bracket and rubber spacer, and into the speaker cabinets threaded hole (see figure 7).

9Install the female knob on the bottom of the Script by threading a fiber washer onto the threaded stud projecting for the bottom of the speaker cabinet, then screwing the female knob onto the threaded stud (see figure 7).

Figure 8.

10Your Script is no mounted on the wall (see figure 8). To direct the speaker at the listening position, loosen the top and bottom knobs slightly and pivot the speaker to the optimum angle. Re-tighten the knobs.

Mounting the Script 9