on the floor or solid surface, it can shake as it produces sound and, consequently, the sound can be compromised. If your speaker is sitting on the carpet and only foot gliders are used, the bass can be ill defined and even boomy. The use of spikes is recommended to insure secured footing for your speakers. (See ‘Solid Footing’ for spike information and installation instructions).
Dipolar Speakers and Your Room
MartinLogan electrostatic loudspeakers are known as dipolar radiators. This means that they produce sound from both their fronts and their backs. Consequently, musical information is reflected by the wall behind them and may arrive, either in or out of step, with the information produced by the front of the speaker.
The low frequencies can either be enhanced or nulled by the position from the front wall. Your Scenario’s have been designed to be placed two to three feet from the front wall (the wall in front of the listening position) to obtain the best results; however, your room may see things differently. So listening to the difference of the bass response as a result of the changes in distance from the front wall can allow you to get the best combination of depth of bass and tonal balance.
Now that you know about reflective surfaces and resonant objects, you can see how the midrange and high frequencies can be affected. The timing of the initial wave as it radiates to your ears, and then the reflected information as it arrives at your ears later in time, can result in confusion of the precious timing information that carries the clues to imaging. Consequently the result is blurred imaging and excessive brightness. Soft walls, curtains, wall hangings, or sound dampeners (your dealer can give you good information here) can be effective if these negative conditions occur.
Solid Footing
After living and experimenting with your Scenario’s, you may want to use ETC (Energy Transfer Coupler) Spikes (See Figure 5), which are available from your local MartinLogan dealer or on our website at www.martinlogan.com. With the use of these spikes, the Scenario will become more firmly planted on the floor and, consequently, bass will tighten and imaging will become more coherent and detailed. It is best not to implement the spikes, however, until you are secure in the positioning, as the spikes can damage the floor if the speaker is moved. MartinLogan ETC spikes will fit any common 1/4” inch thread insert that may be found on your other audio equipment (racks, speakers, etc.)
Spike Installation Instructions:
1.Carefully lay your speaker on its side to gain access to the bottom.
2.Remove existing feet or spikes. Thread new spikes into holes and screw them in all of the way.
3.Tighten jam nut snugly by hand. Do not over tighten the nut.
4.Right the speaker.
Caution: Make sure your hands and any cabling are clear of the spikes. Do not slide speaker as spikes are sharp and can damage your floor or carpet.
5.Adjust to level by rotating spikes. Tighten the jam nut securely when satisfied that speaker is level.
Caution: Walking the speaker may result in a broken spike.
Figure 5. The ETC Spike.
