MartinLogan STAGECenter Channel Speaker user manual 9Hold the bracket at the mounting location

Figure 7. Installing a toggle bolt wall anchor.

®

Figure 8–9. Attach the stand to the wall using 4 screws. Install the Stage.

8Install TOGGLER® SNAPTOGGLE® toggle bolts at all locations with a 1/2-inch hole. To do this:

A)Hold the toggle bolt metal channel flat alongside the plastic straps. Slide the metal channel through the 1/2- inch hole.

B)Hold the ends of the straps between thumb and fore- finger and even them out. Pull the entire toggle bolt toward you until the channel rests flush behind the wall. Slide the plastic cap along the straps with the other hand until the flange of the cap is flush with the wall.

C)Place a thumb between the straps at the wall. Push the thumb side to side, snapping off the straps level with the flange.

U.S. Patent No. 6,161,999 and foreign counterparts thereof and of U.S. Patent No. 4,650,368. TOGGLER and its typeface and SNAPTOGGLE are worldwide registered trade- marks of Mechanical Plastics Corp. For further technical information on these anchors, visit www.toggler.com/products_hwh.html.

12 Installation

9Hold the bracket at the mounting location.

Install the 10-24 x 1.25-inch machine screws in any locations where toggle bolt wall anchors were placed.

Install a lag bolt and washer at any location where a stud was found.

10With the help of an assistant, line up the Stage speaker with the mounted bracket and attach it using the two large knobs.

IMPORTANT! There should be four press fit washers—two attached to the bracket and two attached to the speaker cabinet. When correctly installed these washers should be flush next to each other between the bracket and speaker cabinet.