USING YOUR MICROSENTRY™ REFRIGERATOR CONTROL
Figure 6
Control
Assembly
|
|
|
|
| Control |
| Door Switch |
Alarm |
| F |
| Figure 7 |
| Light Switch | |
|
|
|
|
| |||
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
Set | Colder | Warmer | ON/OFF | control |
|
|
|
Press and Hold |
|
| Press and Hold |
|
|
|
|
Starting your refrigerator
Plug the refrigerator power cord into a wall outlet. Your refrig- erator will begin cooling a few seconds after power is applied. If your refrigerator does not start, check that the refrigerator is turned on and the setpoint is cold enough.
Turning your refrigerator ON or OFF
If the refrigerator is on, the refrigerator temperature will be shown on the display. To turn the refrigerator off, press and hold the “ON/OFF” button for three (3) seconds. “OFF” will appear on the display.
If the refrigerator is off. “OFF” will be shown on the display. To turn the refrigerator on, press and hold the “ON/OFF” button for three (3) seconds. The refrigerator temperature will be shown on the display.
Set temperature
To set the refrigerator temperature, press and hold the “SET” button. When the “SET” button is pressed, the display will show the set temperature. While holding the “SET” button, press the “WARMER” or “COLDER” buttons to adjust set temperature.
Refrigerator operation
The available temperature range of the refrigerator is 35° to 43°.
It may take up to 24 hours for your refrigerator to reach desired temperature. This will depend on amount of content loaded and number of door opening and closings.
For best results allow refrigerator to “pull down” to desired set point before loading. Once contents are loaded, allow at least 48 hours for temperature to stabilize before making any adjust- ments to the set point.
Alarms
Your MicroSentry™ refrigerator control will monitor refrigerator function and alert you with a series of audible and visual alarms. 
• Door Ajar Alarm: If the door has been left
open for over five (5) minutes, the alarm
will sound in one (1) second intervals. The display panel will flash “do” and the LED light will be a steady amber color. This will stop as soon as the door is closed.
• Temperature Sensor Fault: If the controller
detects that a temperature sensor is
not properly functioning, a temperature
sensor alarm will sound. “E1” or “E2” will flash on
the display, and an audible alarm will sound. Please call AGA MARVEL Customer Service or your
dealer if this error code is displayed.
Alarm Mute
Press any key to mute the audible portion of an alarm.
6
