OPERATION
•Keypad Lockout Feature (Loc)
This feature is useful for prohibiting changes in the temperature set point or accidentally turning the unit off. Press and hold the “SET” key to display the cur- rent “Loc” setting. If “No” is displayed, Lockout is OFF and all keys are enabled. If “Yes” is displayed, Lockout is ON and the “ON/OFF”, “WARMER”, and “COLDER” keys are disabled. However, the key tones remain enabled. While holding the “SET” key, press the “WARMER” or “COLDER” key to select the desired state. Release the “SET” key to confirm the selection.
NOTE: The Information/Lockout Key “SET” remains enabled regardless of the “Loc” setting.
Warning Alarms
Your wine cellar has been fitted with a MicroSentry™ refrigeration monitor. This monitor will let you know if your cellar is not functioning properly for optimum wine storage.
Door Ajar Alarm
If the door has been left open for over five minutes, the alarm will sound in one second intervals. The display panel will flash “Do” and the LED light will be a steady amber color. This will stop as soon as the door is closed.
High and Low Temperature
If your unit reaches an unacceptable temperature outside of your set point for more than one hour, the alarm will sound in one second intervals. The display panel will flash either “Hi” or “Lo” depending upon the condition and the LED light will be a steady amber color. “Hi” indicates that the temperature is 10 degrees F above the set point and “Lo” indicates that the temperature is 10 degrees F below the set point. These alarms will warn you that your wines have seen temperatures that may not be conducive for long term storage. The alarm will remain active until the condi- tion is corrected.
NOTE: During initial appliance
Alarm Codes
The control monitors and stores select unit parameters and will display error codes with sound each time a fault is detected. See reference below for a description of each error code.
| Error Code Detection Reference | |
|
|
|
Error Code |
| Description |
|
|
|
Do |
| Door Open |
|
|
|
Hi |
| High Temperature |
|
|
|
Lo |
| Low Temperature |
|
|
|
E1 |
| Sensor Fault |
|
|
|
CL |
| Condenser Coil Cleaning Recommended |
|
|
|
Audible Alarm Mute
Press any key to mute the audible portion of an alarm condition. Alarm sound is only muted, not disabled. If the condition(s) that caused the alarm(s) continue, visual indication will continue and alarm sound will periodically
continue for 20 seconds every 60 minutes.
4