ONE YEAR FULL WARRANTY
Your Master battery powered soldering tool was carefully tested and inspected before it was shipped from the factory. We warrant this product to be free from defects in materials and workmanship under normal use and service for one year from date of purchase. In the event of a defect in materials or workmanship, we will either repair or replace, without charge, at our option, any part which in our judg- ment shows evidence of such defect.
This warranty does not apply to the attachments/tips/batteries,which are items requiring periodic replacement, nor does it apply if the tool has been misused, abused, altered, tampered with. This warranty does not cover any of the following:
1.Battery exhaustion, 2. Battery leakage, 3. Damage to or failure of the Micropro or any component thereof due to alteration, misuse, battery leakage or lack of mainte- nance. At the end of the warranty period, Master Appliance shall be under no further obligation expressed or implied. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
Master Appliance assumes no responsibility for and this warranty shall not cover any incidental or consequential damages from any defect in this product or its use. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply to you.
This warranty gives you specific rights and you may also have other rights which may vary from state to state.
For warranty repair a proof of purchase receipt or other appropriate proof of date is required with your return for warranty repair to Master Appliance. All warranty claims must be made to Master Appliance and not the distributor. We decline responsibility where repairs have been made or attempted by others. Any different guarantee made by others is not authorized by us. If a warranty claim is to be made please return your tool prepaid, with proof of purchase and a note describing the problem to our customer service department. See below.
For repair service we charge a flat rate fee. Please call Master Appliance for the flat rate charge. Return your tool prepaid, with a note describing the problem.
TROUBLE SHOOTING |
|
PROBLEM | SOLUTION |
LAMP GOES ON BUT TIP DOES NOT HEAT UP
Check to ensure tip is fully seated.
TIP HEATS BUT LAMP IS DIM | Replace lamp. | |
TIP DOES NOT HEAT UP AND | Replace exhausted batteries. |
|
LAMP DOES NOT GO ON | Reorient battery position in unit. | |
| (See battery orientation section in manual.) | |
|
|
|
OPTIONAL ACCESSORIES |
|
|
Conical Tips | 35364 | .5mm (standard) |
| 35367 | 1mm |
| 35370 | 1.5mm |
Spade Tips | 35365 | .8mm |
| 35368 | 1.3mm |
| 35371 | 1.8mm |
Chisel Tips | 35366 | 1.0mm |
| 35372 | 1.5mm (standard) |
Tip Remover | 35373 | (standard) |
Tool |
|
|
Protective | 35374 | (standard) |
Cap |
|
|
1.5V AA | 35375 | pkg of 4 |
Alkaline |
|
|
Batteries |
|
|
|
|
|
AA AA AA AA
Master Appliance Corp. Phone: (262)
2420 - 18th St.Fax: (262)
Racine, WI 53403 www.masterappliance.com
P/N 58237
