STEP 17.
5
E
Secure warming rack (5) to rack sup- port bolt (C) using lock nut (E) as shown.
Note: Be sure not to overtighten lock nut, as rack is to mover freely.
Secure warming rack support arm
10
D
STEP 3.
Attach leg bracket (10) to right short legs (8) as shown using phillips head screws (B) and hex flange nuts (D).
Do not fully tighten screws at this time.
Aonto grill body (2) using phillips screw
(A) and hex lock nut (E).
2 | Repeat step on opposite side. |
|
E
B
STEP 18a. |
|
|
| FIGURE E | |
|
|
|
16
15
16
STEP 18a.
Position adjustable charcoal rack lifter (16) on charcoal rack (15) as shown in Figure E. Repeat step on opposite end.
STEP 18b.
Position charcoal tray lifter (16) on side supports in grill body as shown. Use cooking grate lifting tool
8
STEP 18b.
3
16
(24)to place cooking grates (3) into grill body. Note: Cooking grate lifting tool (24) included with model 20043011 only.
STEP 18c.
Insert grease clip (23) up through large hole in bottom of grill body. Engage clip end in small hole.
Position an empty metal container (not included) on grease clip so it rests snugly. The container is needed to collect grease
Note: Clip may require adjustment to fit diameter of container.
8
STEP 4.
Insert axle (11) through holes on short right legs (8). Slide wheel (13) onto axle and secure using cotter clip
(I). Snap axle cap (12) onto end of wheel assembly as shown.
Repeat step on opposite side for remaining wheel.
Do not fully tighten screws at this time.
STEP 18c.
24
23
GRILL IS READY FOR USE
11
12 | 13 |
I | 6 |
13
