HOW TO USE CONTROL PANEL & REMOTE CONTROL
*Batteries not
included
To replace batteries:
•Slide belt clip to the left to remove.
•Press tab down on battery cover and pull out.
•Install 2 “AAA” Alkaline batteries. Check positive (+) and negative
•Replace the battery cover.
•Remove batteries before storing remote control.
To test frequency range:
•Turn unit on.
•Use remote to turn light on and off as you move away from unit.
•Remote control is out of frequency range when light will no longer turn on and off.
IMPORTANT
•Do not leave remote control exposed to sunlight for prolonged periods of time.
•Remote control has frequency range of up to 100ft (30m).
•Test frequency range before and during use.
TROUBLESHOOTING
If the remote is not working properly or not interfacing correctly with the controller, it may be due to weak batteries, batteries being incorrectly installed or the remote is not correctly linked to controller.
Possible solutions
•Replace batteries and install according to image in battery housing
•Link remote and controller by:
a.Turn Controller & Remote “ON”,
b.Press and HOLD “SET TEMP” on controller for 3 seconds.
c.On the Remote press “MEAT PROBE”, “LIGHT”, “MEATPROBE”, “LIGHT” (all buttons must be pressed within 5 seconds of each other) A short beep will occur after each button press.
CAUTION
•Keep batteries away from small children. If battery is swallowed consult a physician immediately.
•Be sure to insert batteries correctly. Improper installation may result in leaks and/or possible explosion.
•Do not dispose of batteries in fire.
•Do not mix old and new batteries.
•Do not mix alkaline, standard
13
