Maxxsonics Q4.1500D, Q4.80 installation manual Q1.1500D, Mono Amplifiers, Mono Subwoofer

Q1.1500D

Mono Amplifiers

Interconnect cable checklist:

Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables.

Use at least #12 gauge speaker wiring. The amps have dual speaker terminals, simplifying the hookup of multiple speakers. These amps are mono, 1 channel, amplifiers which have multiple positive and negative connections for ease of wiring. The 2 positives are the same internally and the 2 negatives are the same internally.

Control checklist:

Refer to the section “Settings for Best Performance”

Minimum final loudspeaker impedance: 1-Ohm.

MONO

SUBWOOFER

DESIGNATED

MONO OUTPUT FROM HEAD UNIT

MIN MAXX

MBQR-2

R	L	OUTPUT
		INPUT
INPUT	BALANCED

	REMOTE
MASTER OUTPUT	SLAVE INPUT

				GREEN-PRE CLIP
		PROTECT		AMBER-SOFT CLIP
				RED-HARD CLIP
		POWER
				CLIP INDICATOR
	LEVEL		CONTROL
				Q-LINK
	9V	0.2V		INPUT	OUTPUT
				SLAVE	MASTER
	PHASE SHIFT			SUBSONIC
0		180		15Hz	35Hz
	PARAMETRIC BASS EQ
	BASS BOOST			LOW PASS
	0dB	12dB		35Hz	200Hz
	BANDWIDTH			BASS FREQUENCY
				30Hz	80Hz
	WIDE	NARROW

PRE-AMP X-OVER

OUTPUT	-
	-
SPEAKER	+
	+

POWERINPUT	BATT+12VREM GND	CHASSIS GROUND
		VIA FUSE
		REMOTE TURN-ON
		TO BATTERY + 12 Volts
	FUSE

6