Maxxsonics SS75.4, SS500.1, SS75.2 SS1000.1D / SS1500.1D / Mono Amplifier Applications, Autotek

SS1000.1D / SS1500.1D / MONO AMPLIFIER APPLICATIONS

Basic application

These sub bass amplifiers can be used in any of the bi-amplification systems described in this manual, replacing the 2 channel amplifiers as per the illustrations.

Interconnect cable checklist:

Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables. Connect the LINE OUT to the inputs of the system highs amplifier.

Use at least #12 gauge speaker wiring. The amps have dual speaker terminals, simplifying the hookup of multiple speakers

SUBSONIC:15 Hz to 35 Hz

BASS EQ: 0 to +12dB

PHASE: 0 to 180 degrees

Level control checklist:

Refer to the section “Setting up systems after installation for best performance”

Minimum final loudspeaker impedance: 1-Ohm.

Crossover frequency control checklist: LOW PASS: 35Hz to 250Hz

DESIGNATED MONO

OUTPUT FROM HEAD UNIT

autotek

0dB 18dB

ATR-1

R
		INPUT
R	L	OUTPUT
		BALANCED
9V	INPUT
		LEVEL
0.
2V
0 180		PHASE
		REMOTE
0dB 12dB		BASS EQ
15 35Hz		SUBSONIC
35		LOW
250Hz		PASS
PRO		PWR

MONO

SUBWOOFER

SPEAKER - - + +

POWER REM +12V	TO BATTERY +12 Volts VIA FUSE
	REMOTE TURN-ON
GND	CHASSIS GROUND

FULL RANGE
STEREO LINE INPUT	Y-ADAPTOR

NOT USED

Note: You can use the Radio/CD designated mono line output

or a full range stereo line output. For full range stereo line output, you will need an optional “Y-Adaptor” as shown

SPEAKER - - +

POWER	+12V
	REM
	GND

PARALLEL MONO

SUBWOOFERS

2-OHMS EACH MINIMUM

9