CHARGE-IT-ALL SPORT
AC/DC LiPO/NiMH/NiCD CHARGER with
Circuitry and Auto Voltage Sensor
| Product Part # 130116 |
|
| |
|
|
|
| |
|
|
|
| |
● AC/DC Input Voltage (110V or 12V) |
|
|
| |
● |
|
|
| |
● 1A, 2A, 3A, 4A or 6A Selectable Charge Rates in NiCD/NiMH Mode |
|
|
| |
● 100mAH, 300mAH, 700mAH, 1.3A or 2A Selectable Charge Rates in Lithium Mode |
|
| ||
● Charges 1 - 8 NiCD or NiMH Cells and |
|
|
| |
● Automatic Voltage Detection | Included with Your Charger: |
|
| |
● Reverse Polarity Protection | ● | ● | Output Cord w/Banana Plugs | |
● Internal Cooling Fan to Reduce Heat | ||||
● 12V DC Input Cord w/Alligator Clips | ● | JST Plug Adapter | ||
● Easy to Set Up and Use | ||||
|
|
| ||
|
|
|
Introduction:
Thank you for choosing the Wattage
Please Read and Understand the Following Warnings:
●This charger is designed to charge
●NEVER connect the AC power and the DC power input cords at the same time and never allow the 12V DC alligator clips to touch or short out.
●When the charger is connected to an automotive battery (12V DC power source), do not start the automobile’s engine. The engine can be running during the charging process, but starting or turning off the engine during the charging process can damage the charger and/or your battery pack.
●Do NOT allow children to use the charger without adult supervision.
●NEVER leave the charger connected to a power source when not in use.
●NEVER leave the charger unattended when the charger is in use.
●NEVER place the charger on a carpeted surface during use.
●ALWAYS disconnect the battery pack from the charger if the battery pack becomes unusually warm or hot.
●AVOID using the charger in direct sunlight.
●ALWAYS allow the battery pack to cool before recharging it.
When charging LiPO battery packs, please read and understand the special warnings listed below. Also make sure to read any and all warnings included in the packaging with your battery. If used improperly, LiPO batteries can be very dangerous, so please follow these warnings and suggestions at all times.
●DO NOT use the product if you do not understand the warnings and proper use of the product.
●ALWAYS let the battery cool and "rest" between uses and charging.
●We recommend the use of a
●DO NOT charge inside your car or inside your house.
●Inspect the battery before each use for swelling or other malformation. If the cell has ballooned, it MUST be discarded.
●Set the charger to 1C (charge at 1/2C or less for the first 5 cycles).
●Check polarity and then connect battery to charger.
●When handling the battery, remember not to poke, bend or damage the cell. The cell outer casing is soft and can be damaged.
●Remember, the cells must never exceed 160 degrees Fahrenheit for any reason.
●LiPO cells may explode or catch fire. Serious injury can result from misuse. Serious injury, loss of property, fire and death can result from misuse of this product.
●All instructions, warnings and cautions must be followed at all times. Failure to do so can lead to serious injury or fire.
●DO NOT overcharge. Maximum voltage for each pack must be followed.
●DO NOT leave in direct sunlight or in a hot car or storage area.
●DO NOT get wet or expose to moisture.
●DO NOT
●DO NOT leave the battery connected when not in use.
●DO NOT operate or charge unattended.
1 |
| Continued On Back Page ☛ |
|