. . . ..*e...................Requirem
ElectricalRequirements
.........................................................................
CAUTION: | Disconnect | electrical power before you start! |
| This dishwasher is designed | for | ||||
All electrical wiring and grounding should be done |
| operation on an adequately wired | |||||||
| individual 120 VAC, 60 Hz |
| |||||||
in accordance with national and local | codes | a |
| ||||||
approved electrical | circuit. |
| |||||||
|
|
|
| * |
| ||||
CAUTION: | To prevent | accidental contact | with electrical | Use required | fuse (15 amp) | or | |||
0 | comparable | circuit | breaker. Two | ||||||
connections, | |||||||||
|
|
|
|
source unless the dishwasher is completely enclosed, with front panels in place. wire with ground service to the | ||
If the back or either side of the dishwasher is exposed, a | dishwasher is recommended for | |
connection at the terminal box | ||
must be used to complete this enclosure | ||
and for grounding | ||
|
GroundingInstructions
.........................................................................
CAUTION: To prevent the possibility of electrical shock, this dishwasher, as other electrical appliances, must be adequately grounded. It is the responsibility of the installer at the point of installation, taking into consideration local conditions and requirements
This appliance must be connected to a grounded metal, permanent wiring system: or an
PlumbingRequirements
. . . . . . ..a . . . . . . . . ..~.....................................................
CAUTION: Disconnect electrical power to dishwasher before you start!
Check local plumbing code for approved plumbing procedures and accessories.
All plumbing should be done in accordance with national and local codes.
DoorSpringAdjustment
.........................................o...............................
The door has two main springs, one located on each hinge. There is a slot on the right hinge that will allow for door adjustment with the accesspanel removed.
To change door spring tension, use a l/4” door spring adjustment bracket.
To increase spring tension: (If door falls coo fast)
Tighten screw by turning clockwise.
To decrease spring tension: (If door falls too slowly)
Loosen screw by turning counterclockwise.
For heavy wood panels, an auxiliary booster spring kit is available.