Maytag 6 915513 A MakingtheElectricalConnections, WaterHookups, FinalizingtheInstallation

Models: 6 915513 A

1 6
Download 6 pages 13.63 Kb
Page 6
Image 6
MakingtheElectricalConnections

MakingtheElectricalConnections

..........................................................

See the Electrical Requirements Section

CAUTION: Verify power to dishwasher is off at source.

0 Remove terminal box cover.

Q In order to secure the power supply cable, a UL listed strain relief must be used to secure the power supply to the back of terminal box.

0strip approximately 3/8” (.09 cm) of insulation from incoming power supply wires. Connect these wires to wires from dishwasher wire harness located in the terminal box. Connect wires using the appropriate size wire nuts, twisting and tightening securely over the wire connections. Connect white to white and black to black.

0 Attach external ground wire from behind washer of green grounding screw. If an external groundwire is used, insert the wire through the cable clamp and attach behind washer of the green grounding screw. Attach the other end of external ground wire to a suitable external ground. If a question arises, refer to your local electrical codes.

OS ecure the strain relief and replace the terminal box cover.

*****************************************************************

WaterHookups

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Check local plumbing codes for approved plumbing procedures and accessories. All plumbing should be done in accordance with national and local codes.

Connect water supply line to water valve. Minimum 3/8” O.D. copper tubing or equivalent.

SHUTOFF VALVE: Install a hand shutoff valve in the water supply line in an accessible location, such as under the sink. The shutoff is optional, but recommended and may be required by local codes. Connections are preferable located toward the left side of the dishwasher. Care should be taken to route plumbing away from motor and blower (if equipped). DO NOT make these connections until the dishwasher is in position.

Care should be taken to protect dishwasher and waterlines leading to dishwasher from freezing. Damage from freezing is not covered by the warranty.

*****************************************************************

FinalizingtheInstallation

..........................................................

@Turn water supply on and check connections for leaks. Q Turn power supply on.

@Re-install Access and Toe panels removed in step 2.

@Run dishwasher through Rinse only or equivalent cycle.

@Check drain hose connection for leak.

6

Page 6
Image 6
Maytag 6 915513 A installation instructions MakingtheElectricalConnections, WaterHookups, FinalizingtheInstallation