Split & Fit™ Utensil Basket
The split silverware basket can be separated and placed in several locations in the bottom rack. Hold the basket firmly along the sides. Follow the unlock direction arrows imprinted on the basket and slide the basket apart until it splits into two. Load flatware and utensils into both sec- tions or just one, depending upon your load.
For best cleaning results, prevent items from nesting together by placing some items in the basket with han- dles up and some with handles down. Load knives, han- dles up, through the slots in the hinged covered sec- tion(s) (when closed).
Be sure that thin, finely pointed items do not extend through the basket. This could block the lower wash arm.
Small, lightweight items like baby spoons and plastic measuring spoons should be placed in the section(s) with the hinged cover(s).
Odds & Ends Basket
Use this supplemental basket in the upper rack for loading miscellaneous items and utensils. This is also a safe place to load sharp knives and pointed items.
Removing the Upper Rack
The upper rack can be removed when tall or oversized items need to be loaded into the lower rack.
Note: Avoid resting items over the center wash tower.
To remove:
•Roll the upper rack 1/3 to 1/2 of the way out.
•Remove the plastic rack stop from the end of each track. To remove each plastic rack stop, push in- ward (towards the rack) on the ridged area of the rack stop. The rack stop will snap open and can be easily removed by pulling straight out. Take care to support the track while removing rack stops.
•Roll the rack all the way out of the track and remove from the dishwasher.
•Reverse the above procedure to replace the upper rack into the dishwasher.
Rack |
Stop |
4
