Maytag 6 915928 A warranty Controls at a Glance, Operating Tips

Auto

Clean

Controls at a Glance (continued)

Delay/Resume

The Delay/Resume option can be used to automatically start the cycle at a later time, such as during off-peak hours for reduced energy cost or to reduce daytime heat buildup in the home.

To Set Up a Delay:

1Select the appropriate cycle and options for the load.

2Press the Delay/Resume pad until the desired amount of delay time (1 to 9 hours) is selected. The delay time will begin counting down when the pad is released.

3The Delay/Resume indicator light will remain lit until the delay time has counted down.

4The cycle will automatically start as soon as the delay time expires.

Note: If Delay/Resume is chosen without selecting a cycle and/or options, the dishwasher will select the last cycle used. (It will not remember the Rinse Only cycle.)

To Cancel a Delay:

Wait at least 2 seconds, then press the Delay/Resume pad again. The indicator light will go out and the cycle will start or resume immediately.

Control Lock Option

The control touchpads can be locked to prevent unwanted use. If this feature is activated between cycles, the dish- washer cannot be operated until the controls are unlocked. If desired, the controls can be locked after a cycle or delay has started.

Note: This option does not lock the door, only the dish- washer controls.

Setting the Control Lock:

1Press the pad for three seconds.

2An indicator light above the pad will illuminate when the controls are locked.

To Cancel:

1Press the pad for three seconds.

2The indicator light will go off.

Note: If a cycle or option pad is pressed after the con- trols have been locked, the indicator light above the Control Lock pad will flash five times.

Operating Tips

Starting The Dishwasher

1After loading the dishwasher and adding detergent, close the dishwasher by pressing the door until the latch clicks.

2To start the dishwasher, firmly press the desired cycle and options pads. After a pause, the fill will begin. To prevent unplanned cycle or option changes, these selections are “locked in” after 1 minute.

3The indicator lights for the selected cycle and options will glow.

4To cancel an option, press the pad again. To cancel a cycle, press the Drain/Off pad.

Note: If a cycle or option pad is pressed after the selec- tions are “locked in”, the indicator light above the Control Lock pad will flash five times.

Adding a Forgotten Item

For best cleaning, the forgotten item should be added early in the cycle.

1Press the Delay/Resume pad or unlatch the door.

2Wait for the water circulation to stop.

3Open the door and add the item.

4Close and latch the door.

•If Delay/Resume was pushed, push it again to restart the dishwasher.

5After five seconds, the cycle resumes automatically at the point of interruption.

Note: Extended interruption of the wash cycle is not recommended.

7