Maytag 760S Positioning the machine, A. Adjusting machines with six feet freestanding dishwasher

Positioning the machine

A. Adjusting machines with six feet (freestanding dishwasher)

1.Adjust the height of the dishwasher with the four steel feet.

2.Lock the feet with the nuts.

NB! The dishwasher must not be allowed to lean more than 5 mm.

Steel feet

3.After the steel feet have been adjusted, screw down the two rubber feet tightly against the floor.

The rubber feet now work as anti-tilt protection.

B. Adjusting machines with three or four feet

1.Start by measuring the height from the floor to the underside of the work surface.

2.Install the sliding feet on the dishwasher.

3.Measure the height from the floor to the top edge of the dishwasher.

4.Adjust all the feet by screwing them

clockwise to raise or anti-clockwise to lower.

5.Check that the height of the machine corresponds to the height from the floor to the underside of the work surface. Tighten the locking nuts (locking nut) on the rear feet.

6.Push the dishwasher into place.

7.Finely adjust the front feet (the machine may lean max. 5 mm) and tighten the lock- ing nuts.

C. Adjusting machines with adjustable foot

1.Start by measuring the height from the floor to the underside of the work surface.

2.Install the sliding feet on the dishwasher.

3.Measure the height from the floor to the top edge of the dishwasher.

4.Tilt the dishwasher forward a fraction and roughly adjust the rear foot by screwing the set screw at the front clockwise to raise or anti-clockwise to lower (illustrated below). Use a broad screwdriver or a hexagonal head screwdriver.

5.Adjust the front feet by turning them clock- wise to raise or anti-clockwise to lower.

6.Check that the height of the machine corresponds to the height from the floor to the underside of the work surface.

7.Push the dishwasher into place.

8.Finely adjust the feet (the machine may lean max. 5 mm) and tighten the locking nuts on the front feet.

32