-3-
DIMENSION “A” SIDE CLEARANCE ABOVE COOKING SURFACE = 3 INCHES (7.6 CM) (MINIMUM)
ANY COMBUSTIBLE SURFACE
13²(33C M) MAX. DEPTH OF
CABINETS ABOVE COOKTOP
0²(0CM) CLEARANCE
BETWEEN ADJACENT
COMBUSTIBLEAND
THE BACK AND SIDES
OF THE RANGE
BELOW THE COOKING
SURFACE.
36²
(91.4 CM)
18²
(45.7CM) MIN.
30²
(76.2 CM)
30²
(76.2CM) MIN.
“A”
“A”
*(SEENOT E ON FRONT PAGE)
NOTE:COOKTOP
MUST BE FLUSH OR
ABOVEC OUNTERTOP
*
Check the range serial plate to see if the range is
approved for installation in mobile homes and/or
recreational park trailers. Serial plate is located on f lip-up
plate at rear of upper left hand corner of backguard.
If approved, the following items are applicable:
Mobile Homes
The installation of a range designed for mobile home
installation must conform with the Manufact ured Home
Construction and Safety Standard, Title 24 CF R, Part
3280 [formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24 HUD, (Part 280)]or ,
when such standard is not applicable, the Standard for
Manufactured Home Installations, ANSI A225. 1/NFPA
501A, or with local codes.
In Canada the range must be installed in accordance with
the current CSA Standard C22.1 - Canadian Electrical
Code Part 1 and Section Z240.4.1 - Installation
Requirements for Gas Burning Appliances in Mobile
Homes (CSA Standard CAN/CSA - Z240MH).
Recreational Park Trailers
The installation of a range designed for recreational park
trailers must conform with state or ot her codes or, in the
absence of such codes, with the Standard for
Recreational Park Trailers, ANSI A119.5-latest edition.
In Canada the range must be installed in accordance with
CAN/CSA - Z240.6.2 - Electrical Requirements for R.V. ’s
(CSA Standard CAN/CSA - Z240 RV Series) and Sect ion
Z240.4.2 - Installation Requirements for Pr opane
Appliances and Equipment in R.V.’s (CSA Standard
CAN/CSA - Z240 RV Series).
Locating The Range
Place range in a well lit area.
Do not set range over holes in the floor or other locations
where it may be subject to strong drafts. A ny opening in
the wall behind the range and in the floor under the range
should be sealed. Make sure the flow of cooling/
ventilation air is not obstructed below the range.
NOTE: A range should NOT be installed over kitchen
carpeting.