HOW TO REMOVE RANGE FOR SERVICING

Follow these procedures to remove appliance for servicing:

1.Slide range forward to disengage range from the anti-tip bracket.

2.Shut off gas supply to appliance.

3.Disconnect electrical supply to appliance, if equipped.

4.Disconnect gas supply tubing to appliance.

5.Reverse procedure to reinstall. If gas line has been disconnected, check for gas leaks after reconnection.

NOTE: A qualified servicer should disconnect and reconnect the gas supply.

The servicer MUST follow installation instructions provided with the gas appliance connector and the warning label attached to the connector.

6.To prevent range from accidentally tipping, range must be secured to the floor by sliding rear leveling leg into the anti-tip bracket.

SERVICE-PARTS INFORMATION

When your range requires service or replacement parts, contact your dealer or authorized service agency. Please give the complete model and serial number of the range which is located on flip-up plate at the rear of upper left hand corner of backguard.

-11-

Page 11
Image 11
Maytag 8101P407-60 installation manual HOW to Remove Range for Servicing, SERVICE-PARTS Information