If the oven is heavily soiled, excessive flareups may result in a fault code during cleaning. Pressthe CANCEL pad and allow the oven to cool completely, wipe out excess soil, then reset the clean cycle. If the fault code reappears, contact an authorized servicer.
Noises may be heard.
The oven makes several low level noises. You may hear the oven relays as they go on and off. This is normal.
As the oven heats and cools, you may hear sounds of metal parts expanding and contracting. This is normal and will not damage your appliance.
There are no beeps and no display.
,Oven may be in Sabbath Mode. See page 16.
SAb flashing and then displayed continuously.
Oven is in Sabbath Mode. To cancel, press and hold the Clock pad for five seconds.
SurfeceCookin9
Surface Controls
Use to turn on the surface elements. An infinite choice of heat settings is available from Low to High. The knobs can be set on or between any of the settings.
When a control is turned on, a glow can be seen through the smoothtop surface. The element will cycle on and off to maintain the preset heat setting, even on High.
4.After cooking, turn knob to OFF. Remove pan.
Setting the Controls
1. Place pan on surface element. |
Dual Elements
The cooking surface has two dual elements
©
2. Push in and turn the knob in either direction to the desired | |
heat setting. |
|
, The control panel is marked to identify which | OO |
| |
element the knob controls. For example, the | OO |
graphic at right indicates left front element. |
3.There is an element indicator light on the control panel. When any surface control knob isturned on, the light will
turn on. The light will turn off when all the surface elements are turned off.
located in the right front and left front ofOFF the smoothtop. This allows you to change
the size of these elements.
Press the switch to the left to use the
large element or to the right to use the small element. The selection should be
made before turning on the element.
9
