Maytag operation manual Brick Installation, Canyon C310 Brick Sizes see Figures on this

Brick Installation

Canyon™ C310 Brick Installation

CAUTION: Wear gloves during brick installation in case of sharp edges behind the stove.

Note: Installation of baffle bricks and ceramic blanket is much easier when you can still access the flue outlet, as in before installing the insert. Be sure the insulating blanket is placed flat on the bricks so as not to block the flue and that it does not hang out over the front of the baffle. Use a ruler or a piece of kindling to reach back over the blanket to be sure it is flat on top of the baffle bricks all the way back.

Install bricks #1-30 in the numbered sequence. (Note: Bricks 22-25 lean up against the lower air channeland butt against bricks 17-21 on the bottom of the stove) Next install bricks 35-40 on top of the stainlesssteel secondary tubes in the upper part of the firebox. These bricks fit up against bricks 26-30 on the backwall and should rest on the rear two stainless steel tube spports running front to rear down the cemter of thestove. Included in your stove are two

Firebox Brick Layout

*These bricks go up against

the stoves back wall.

Figure 1

Baffle Brick Layout

13”x17”x1” thick ceramic fiber blankets. Install a ceramic fiberblanket on top of each of these sets of two sets of three bricks making sure the blanket is pushed fully tothe rear. Next install bricks 41-46 under the ceramic fiber blanket and on top of the front two stainlesssteel secondary tubes.

(Caution: Make sure that the front of the ceramic fiber blanket does notproject beyond bricks 41-46.)

WARNING: IF THE BRICKS AR NOT INSTALLED EXACTLY AS SHOWN THEY COULD FALL OUT OF PLACE DURING REFUELING OR BURNING OF THE STOVE CAUSING SERI-

35		36
				37
	F		F		G
		42
	41			43
	J		J		K

Stainless Steel Tube Support

40		39	38
G		F		F
	45
46			44
K		J		J

OUS INJURY.

Canyon™ C310 Brick Sizes (see Figures on this page)

A = 3-7/8 x 8-3/4”		Side View
			M Brick
B = 6-1/2 x 4-1/2”
C = 3-1/2 x 9”		1/2”
D = 1-1/2 x 4-1/2”
E = 3-7/8 x 9”
F = 4-1/2 x 9”
				M	4-1/2”
G = 3 x 9”
	2-	1/2”
H = 3-1/2 x 4-1/2”
J = 4-1/2 x 7”
K = 3 x 7”
M - 4-1/2 x 4-1/2”

Insulating Blanket Size is 1/2” x 11” x 20” and fits on top of the baffle brick.

Figure 2

Baffle Blanket Placement

Insulating Blanket Baffle Brick

Rear Brick Go	Secondary Burn Tubes
Behind Baffle
Brick

Figure 3



NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.