![Chimney Requirements](/images/new-backgrounds/35565/3556515x1.webp)
Chimney Requirements
The Canyon™ C310 inserts are approved for use in masonry fireplaces built to UBC Chapter 37 or equivalent with a mini- mum 30” opening at the front of the fireplace.
Do not remove brick or mortar from masonry fireplace to accommodate insert. Do not remove brick or mortar from
masonry fireplace to accommodate insert. Approved with or without positive flue connection. Approved with minimum 6” (152mm) diameter stainless steel listed reline system. Ask your dealer for recommended chimney size. Country Collection inserts are tested to UL 1482 / ULC
Remove and clean behind unit frequently, as creosote build up may occur rapidly.
Installation Procedures - Masonry Chimney
NOTE: Although not required, a
Note: When installing your stove with a positive flue connection, be sure to leave the insulation off the surround panels (flanges) and leave a 1/4” (6mm) airspace insulation off the surround panels and the facing of your fireplace.
1. | READ ENTIRE INSTALLATION INSTRUCTIONS. |
2. | Check all REQUIRED CLEARANCES as specified in the previous |
| section (page 7) of this installation instruction booklet. |
3. | Wear gloves during installation in case of sharp edges on the |
5.Open or remove the existing fireplace damper. Make sure the damper cannot fall closed.
6.Install the two 1/2” x 3” (13mm x 76mm) leveling bolts
7.Position the insert in the center of the fireplace opening and push it back until the surround brackets are approximately 2” (51mm) away from the fireplace front.
8.Install the side surround panels and push the insert up snug against the fireplace face. Then with the location selected re- move the surround panels and level the stove with the leveling bolts using a 3/4” (19mm) socket, extensions (to reach the bolt head), and a ratchet.
9.Glue the insulation around the outer edge of both the top and side surround panels.
10.Install the surround panels loosely, align and tighten. Check for a tight fit against the fireplace.
11.Install the brick and baffle as per instructions on page 6.
POSITIVE FLUE CONNECTION: See your authorized Len- nox Hearth Products dealer for necessary accessories and installation instructions.
Positive flue connectors required for installation in Canada are
available from your Lennox Hearth Products dealer. Please use one the part numbers indicated below.
71162 - 8" Positive Flue Connector Ring Kit
71163 - 8" to 6" Reducer w/ Positive Flue Connector
stove and it’s parts |
4. Determine the depth of the fireplace lintel. The lintel is the |
masonry area over the fireplace opening, and is supported by |
a noncombustible plate, usually of steel. The depth may vary |
from a single brick width (4”/102mm) to that of several brick. |
If any portion of the flue collar opening on top of the insert (as |
shown in the diagram below) will project under the lintel area, |
a deflector plate must be mechanically attached to the fireplace |
insert to divert heat and gases away from the lintel. Consult your |
dealer for the correct attachment piece. Compare lintel depth |
to the distance from the flue collar opening to the fireplace to |
determine if this caution pertains to your installation. If there |
is sufficient clearance, a flue offset may also be used. Consult |
your dealer. |
Lintel
Flue Outlet
Figure 6
Brick Face
Insert Surround
Smoke
Deflector
Mechanically
Attached to
Insert
Not to Scale
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.