Maytag FRONT-LOADINGAUTOMATICWASHER manual Location Requirements, Installation clearances

Location Requirements

Selecting the proper location for your washer improves performance and minimizes noise and possible washer “walk.”

Your washer can be installed under a custom counter, or in a basement, laundry room, closet, or recessed area. See “Drain System.”

Companion appliance location requirements should also be considered. Proper installation is your responsibility.

You will need

■A water heater set to deliver 120°F (49°C) water to the washer.

■A grounded electrical outlet located within 6 ft (1.8 m) of where the power cord is attached to the back of the washer. See “Electrical Requirements.”

■Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).

■A level floor with a maximum slope of 1" (2.5 cm) under entire washer. Installing the washer on soft floor surfaces, such as carpets or surfaces with foam backing, is not recommended.

■A sturdy and solid floor to support the washer with a total weight (water and load) of 400 lbs (180 kg).

Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures.

Installation clearances

■The location must be large enough to allow the washer door to be fully opened.

■Additional spacing should be considered for ease of installation and servicing.

■Additional clearances might be required for wall, door, and floor moldings.

■Additional spacing of 1" (2.5 cm) on all sides of the washer is recommended to reduce noise transfer.

■Companion appliance spacing should also be considered.

Washer Dimensions

Recommended installation spacing for custom undercounter installation

The dimensions shown are for the recommended spacing.

Custom undercounter installation - Washer only

39" min. (99.0 cm)

1"	27"		1"
(2.5 cm)	(68.6 cm)	(2.5 cm)

Recommended installation spacing for recessed or closet installation, with or without a pedestal

The dimensions shown are for the recommended spacing.

Recessed area or closet installation

				3"
				(7.6 cm)
		34"	48 in.2 *
	(86.4 cm)		(310 cm2)
			24 in.2 *	3"
			(155 cm2)
				(7.6 cm)
1"	31¹⁄₂"	4"
(2.5 cm)	(80 cm)	(10.2 cm)

AB

A. Side view - closet or confined area

B. Closet door with vents

Recessed or closet installation - Washer on pedestal

18" min.

(45.7 cm)

50¹⁄₂"

27"

(68.6 cm)

(128.3 cm)

38"

(96.5 cm)

1"	27"		1"		1"		31¹⁄₂"	4"
(2.5 cm)	(68.6 cm)	(2.5 cm)		(2.5 cm) (80 cm) (10.2					cm)
	A					B

A. Recessed area

B. Side view - closet or confined area

31¹⁄₂"

(80.0 cm)

5