Maytag LMDV-33 SERIES, LMDV-40 SERIES, LMDV-35 SERIES Removing Glass Enclosure Panels, see Figure

	Top Flange on
	Glass Door
	Glass Door
Bottom Vee-flange
Glass Door	Firebox Floor
	Glass Door Latch
Figure 6 - INSTALLING GLASS DOOR

Removing Glass Enclosure Panels

(see Figure 6)

1.Remove the top louver assembly by pulling it up and out.

2.Remove the control compartment access door (see removal instructions on Page 4 - Removing Control Compartment Door).

3.Locate the two (2) latches at the top of the control compartment. To disengage the two latches from the bottom vee-flange of the glass enclosure panel, reach for the handles located towards the back of the latches and pull the handles down toward the front of the appliance.

4.Swing the bottom of the door out and raise it slightly to lift the top flange of the door frame away from the appliance.

Installing Glass Enclosure Panels

(see Figure 6 )

1.Visually inspect the gasket on the backside of the glass panel. The gasket surface must be clean, free of irregularities and seated firmly.

2.Position the glass enclosure panel in front of the firebox opening at a 45 degree angle and engage the top flange over the lip at the top of the firebox opening. See Figure 6.

3.Swing the glass enclosure panel down and back. Ensure the gasket seats evenly as the panel draws shut. Engage the Vee-flange at the bottom of the panel with the latches and close the latches to secure the panel.

4.Reinstall the control compartment door see installation instructions on Page 4 , Reinstalling Control Compartment Door).

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

7