SETTING UP + INSTALLATION
Note: we recommend you keep the transit bracket, braces and screws to immobilise the machine for future transit.
1
2 
3
Remove the polystyrene base and place the machine near its permanent position (diagram 1).
Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2).
Unscrew the central bolt (A); unscrew the 4 lateral screws
(B) and remove the cross piece (C) (diagram 3).
Lean the machine forward and remove the plastic bags containing the two polystyrene blocks at the sides, pulling downwards (diagram 4).
Press the plug (to be found in the envelope with the instructions) into the hole and rotate to lock into position (diagram 5).
4 |
| 5 |
|
|
|
The Manufacturers will not be responsible for any possible damage to the machine caused by not following the rules relating to releasing the mechanism. The user is responsible for all costs of installation.
Water connection
The appliance must be connected to the water mains using new
The machine has an inlet hose with 3/4" B.S.P threaded end connection to attach between the threaded connector on the appliance and the cold water supply.
The appliance must only be connected to the cold water supply. Connection to a warm water supply, that is over 40°C, may damage certain delicate fabrics.
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL SOURCE OF DANGER.
Apply the insulation sheet of corrugated material to the base as shown.
Level the machine by means of the front feet. |
|
a) Turn the nut clockwise to release the screw adjuster on the foot. | A |
b) Rotate the foot to raise or lower it until it stands |
|
firmly on the ground. | B |
c) Lock the foot in position by turning the nut | |
|
C
| min 4 cm | |
cm | +2,6 mt max | |
100 | ||
max 85 cm | ||
max | ||
| min 50 cm |
26 | 27 |