CARE AND CLEANING
Control Panel – clean with a soft, damp cloth. Do not use abrasive substances.
Tumbler – remove any stains such as cray- on, ink pen or fabric dye (from new items such as towels or jeans) with an
stance. Once these steps are done, stains may still be visible, but should not transfer to subsequent loads.
Cabinet – wipe off any marks with soap and water.
Dryer Exhaust System – should be inspected and cleaned once a year to main- tain optimum performance. The outside exhaust hood should be cleaned more fre- quently to ensure proper operation. (Refer to the Installation Instructions for more infor- mation.)
REPLACING THE DRUM LIGHT
Instructions for replacing the bulb:
1)Unplug or disconnect the dryer from the electrical power supply.
2)Open the door and use a Phillips screw- driver to remove the screw attaching the lens to the tumbler front.
3)Remove lens cover by pulling cover toward center of tumbler.
4) | Rotate bulb | 8) | Reinstall the screw into the lens cover |
| remove from socket. |
| screw hole. |
5) | Replace the bulb with a 120 volt, 10 watt | 9) | Reconnect dryer to power supply. |
| maximum candelabra base light bulb. |
|
|
6)Turn the light bulb clockwise into socket.
7)Replace lens cover by hooking plastic tabs into tumbler front below the light housing.
REVERSING THE DOOR
Directions for reversing the dryer door:
1)Remove the hinge hole covers and screws.
2)While supporting the door, remove 2 screws in the hinges that secure the hinges to the cabinet.
3)Remove door by lifting slightly at the hinges and pulling the hinge tabs out of the hinge slots.
4)Move the following parts to the opposite side of the door: 2 hinges and 4 hinge screws, 4 door screws, door strike and screw, inner door cover plate and screw.
5)Attach the door to the opposite side of the cabinet using the 2 counter sunk hinge screws. (See below).
Screw the lower hinge screw in first. This will help to align the door and hinges.
6)Replace the hinge hole covers to the opposite side.
8
