SETTING SENSOR DRY
Step 4
Review Screen – The Review Screen lists the selected settings. At this point you may press Start/Pause to begin drying the load or select “options” for further customization of the drying cycle.
Step 5
Options Screen – The option choices on the left turn the options on or off. The option choices on the right show an additional screen with multiple choices. The following options may be added to customize your “sensor dry” cycle:
•“wrinkle prevent” - Intermittent tumble in room temperature air for up to 95 minutes following the dry cycle.
•“damp dry chime” - Chimes when load reaches damp dry state.
•“remind chime” - Chimes at the end of the cycle every 5 minutes for up to two hours.
•“end of cycle chime” - Chimes once when the selected dryness level is reached.
When the desired selections are made, touch “continue” to see the review screen once again.
Step 6
Review Screen – The review screen will appear once again to verify your selections. If they are correct, press Start/Pause. If they are incorrect, press the area you would like to change.
Special Note: As you use the touchscreen, if you feel you are lost, press Back or Home.
SETTING TIME DRY
Step 1
Select “time dry” from the Home screen. The control defaults to 45 minutes.
Step 2
Press the up and down arrows to set the appropriate number of minutes to dry the load. The time will increase or decrease in one minute increments. Press “continue” when done.
7
