Removing the Upper Rack
The upper rack can be removed when tall or oversized items need to be loaded into the lower rack.
TO REMOVE:
➢Roll the upper rack 1/3 to 1/2 of the way out.➢Remove the plastic rack stop from the end of each track. To remove each
plastic rack stop, push inward (towards the rack) on the ridged area of the rack stop. The rack stop will snap open and can be easily removed by pulling straight out. Take care to support the track while removing rack stops.
➢Roll the rack all the way out of the track and remove from the dishwash- er.
➢Reverse the above procedure to replace the upper rack into the dish- washer.
PORTABLE DISHWASHER |
Rack |
Stop |
PORTABLE DISHWASHER
Connecting a portable
1. | Turn on the faucet at the sink until the |
| water runs hot. Turn off the faucet. |
2. | Pull the connector from the recess in |
| the back of the dishwasher. |
7. | Pull the electrical cord from the recess. | 3. | Push the connector and hoses back |
| Plug it into a properly grounded outlet. |
| into the cabinet recess. |
8. | Select the proper cycle and options for | 4. | Unplug the electrical cord and push it |
| the load and start the dishwasher. |
| back into the cabinet recess. |
3. | Press down on the thumb release and |
| lift the connector onto the faucet. |
4. | Remove pressure from the thumb |
| release and tug slightly on the connec- |
| tor to be sure it is securely in place. |
5. | Turn the hot water on full force. |
6. | Check that the sink drain is open so |
| water from the dishwasher can drain |
| properly. |
Disconnecting a
Portable
1.Be sure to turn the water supply off and press the pressure release button BEFORE removing the connector.
2.Press down on the thumb release and remove the connector from the faucet.
Thumb Release |
Faucet |
Connector |
Pressure |
Release |
Button |
4