GETTING STARTED

LAUNDRY

To dry a load of laundry the following steps are taken. They are discussed in greater detail in later sections.

1.Clean the lint filter.

2.Load the dryer properly.

3.Add fabric softener sheet (if desired).

4.Set dryer programme.

TOUCHSCREEN

Home - Takes you immediately to the first screen.

Touchscreen - An interactive display that responds with the touch of a finger.

Note: Exposure of the touchscreen to direct sunlight is not recommended.

Off - Stops the dryer and turns off the display.

Home

timed dry

freshen up

sensor dry

crease removal

 

 

air fluff

favourites

(no heat)

 

Favourites - Quick access to your named cycles.

 

 

Help - Quick access to

Back - Takes you to the

 

Troubleshooting, Laundering

previous screen.

 

Hints, Operating Tips, Lock

 

 

Out and Select Preferences.

 

 

 

Start/Pause - Press this pad to start a cycle. Once started, pressing this pad will stop the dryer at any point in the cycle.

If there are no words on the touchscreen, open the door, touch any key (except OFF), or touch the screen to “wake” the controls. The machine will beep three short beeps if an invalid key sequence is pressed.

Power Outage – If the machine is running during a power cut, the machine will go into “PAUSE” mode. When power returns, the screen will display a power failure message. Press “OK” to continue.

Special Note: As you use the touchscreen, if you feel you are lost, press Back or Home.

3

Page 4
Image 4
Maytag MDE7550AGW important safety instructions Getting Started, Laundry, Touchscreen