You will need:
nA water heater set to 120° F (49° C).
nA grounded electrical outlet located within 4 ft (1.2 m) of power cord on back of washer.
nHot and cold water faucets located within 3 ft (0.9 m) of hot and cold water fill valves on washer, and water pressure of
nA level floor with maximum slope of 1" (25 mm) under entire washer. Installing on carpet is not recommended.
nFloor must support washer’s total weight (with water and load) of 315 lbs (143 kgs).
IMPORTANT: Do not install, store, or operate washer where it will be exposed to weather or in temperatures below 32° F (0° C). Water remaining in washer after use may cause damage in low temperatures. See “Washer Care” in your Use and Care Guide for winterizing information.
Proper installation is your responsibility.
Recessed area or closet installation
3"
(76 mm)
14" max. | 48 in.2 |
(356 mm) | (310 cm2) |
17"
(432 mm)
|
| 24 in.2 |
5" |
| (155 cm2) |
(126 mm) |
|
|
| 1" | 3" |
1" | (25 mm) | |
(25 mm) |
| (76 mm) |
Dimensions show recommended spacing allowed, except for closet door ventilation openings which are minimum required. This washer has been tested for installation with spacing of 0" (0 mm) clearance on the sides. Consider allowing more space for ease of installation and servicing, and spacing for companion appliances and clearances for walls, doors, and floor moldings. Add spacing of 1" (25 mm) on all sides of washer to reduce noise transfer. If a closet door or louvered door is installed, top and bottom air openings in door are required.
DRAIN SYSTEM
Drain system can be installed using a floor drain, | wall standpipe, | ||
floor standpipe, or laundry tub. Select method you |
| need. | |
Floor standpipe drain system |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
Minimum diameter for a standpipe drain: 2" (51 mm). Minimum
Wall standpipe drain system
See requirements for floor standpipe drain system
Floor drain system
Floor drain system requires a Siphon Break Kit (Part Number 285834), 2 Connector Kits (Part Number 285385), and an Extension Drain Hose (Part Number 285863) that may be purchased separately. To order, please see
Laundry tub drain system
Minimum capacity: 20 gal. (76 L). Top of laundry tub must be at least 39" (990 mm) above floor; install no higher than 96" (2.44 m) from bottom of washer.
IMPORTANT: To avoid siphoning, no more than 4.5" (113 mm) of drain hose should be inside standpipe or below the top of wash tub. Secure drain hose with beaded tie strap.
3
