Maytag MVWX700XL Electrical Requirements Installation Instructions, Move washer

ELECTRICAL REQUIREMENTS INSTALLATION INSTRUCTIONS

Before you start: remove shipping materials

It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer.

nA 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit breaker serving only this appliance be provided.

nThis washer is equipped with a power supply cord having a 3 prong grounding plug.

nTo minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician.

nIf codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.

nDo not ground to a gas pipe.

nCheck with a qualified electrician if you are not sure the washer is properly grounded.

nDo not have a fuse in the neutral or ground circuit.

1. Move washer

48"

(1.2 m)

Move washer to within 4 ft (1.2 m) of its final location; it must be in a fully upright position.

NOTE: To avoid floor damage, set washer onto cardboard before moving it and make sure lid is taped shut.

2. Remove shipping base

To avoid damaging floor, place cardboard supports from shipping carton on floor behind washer. Tip washer back and place on cardboard supports. Remove shipping base. Set washer upright.

IMPORTANT: Removing shipping base is necessary for proper operation. If your washer includes a sound shield, please refer to the instructions included with the sound shield to install it at this time.

4