Timer Installation
Note: The ECXTRA indoor timer is not weather resis- tant and must be installed indoors or in a protected area.
Indoor Model Installation
1.Select a location for the timer within 4′ (1,2m) of an electrical outlet to enable the transformer cord to easily reach. Make sure the outlet is not controlled by a light switch or used to power any large appliance such as a refrigerator, freezer, or air conditioner.
2.Remove the mounting bracket attached to the back of the timer housing by pulling the lower edge of the bracket away and downward from the timer housing.
3.Place the mounting bracket (A) against the wall aligning the top edge at about eye level. Drive two stainless steel screws (B) into the wall through two holes provided in the bracket. For additional stability, secure the bracket with three screws.
Note: If you are installing the bracket on drywall or masonry, install screw anchors (C) to prevent screws from loosening.
4.Optional - Insert 3/4″ (19mm) PVC conduit (D) for valve wiring into bracket sleeve (E).
5.Align the slotted openings on the back of timer hous- ing with the mounting bracket tabs. Slide the timer
downward to engage the tabs.
A
F
B
C
E
D
Note: After installation, store the Quick Start Guide in the pocket (F) formed between the timer and bracket.
