CARE AND CLEANING
Turn off the water faucets after finishing the day’s washing. This will shut off the water supply to the clothes washer and prevent the unlikely possibility of damage from escaping water. Leave the door open to allow the inside of the washer to dry out.
Use a soft cloth to wipe up all detergent, bleach or other spills as they occur.
CLEANING THE INTERIOR
Clean the interior of the washer periodically to remove any dirt, soil, odor, mold, mildew or bacteria residue that may remain in the washer as a result of washing clothes. We recommend taking the following steps every 60 to 120 days to clean and freshen your washer interior. The frequency with which the washer should be cleaned and freshened depends on factors such as usage, the amount of dirt, soil or bacteria being run through your washer, or the use of cold water. Failure to follow these instructions may result in unsatisfactory conditions, including unpleasant odor and/or permanent stains on the washer or washload.
Clean the following as recommended:
Control Panel – Clean with a soft, damp cloth. Do not
use abrasive powders or cleaning pads. Do not spray cleaners directly on the panel.
Cabinet – Clean with soap and water.
To clean and freshen the washer interior:
1. Make a solution of one cup chlorine bleach and two cups warm water. Be careful not to spill or splash the bleach solution.
2. Wipe the door seal with bleach solution and a soft cloth.
3. Fill bleach dispenser with chlorine bleach.
4. Run the washer through a complete cycle using hot water.
5. Repeat the wash cycle if necessary.
Hard water deposits may be removed, if needed. Use a recommended cleaner labeled clothes washer safe.
CLEANING THE DISPENSERS
The Automatic Dispenser may need to be cleaned periodically due to laundry additive buildup.
1. Press the release lever on the inside of the dispenser and pull out.
BLEAC | H |
SOFT |
|
UP FOR | DOWN FOR |
POWDER | LIQUID |
UP FOR | DOWN FOR | BLEACH |
POWDER | LIQUID | SOFTENER |
2. Remove the cups from the fabric softener and bleach compartments.
3.Wash all of the parts under running water.
4. Clean the dispenser recess with a soft brush.
5. Reinsert the cups, pushing them firmly into place.
6. Push the dispenser back into place.
7. Run a Rinse & Spin cycle without any load in the
washer.11
Siphon Cap