INSTALLATION
1.Remove and discard shelf packing clips.
2.Do not install where the room temperature will go below 55 degrees F. It will not run frequently enough to maintain proper temperature in the freezer,
3.Allow a free flow of"air through the front base grille.
4.For ease nf installation, leave a space of about 1/2 inch between the refrigerator and adjacent walls or cabinets. If placed with the hinge side against a wall, leave additional space so the door can be opened w_der. (Refer to the installation instruetlans for more detail.)
,5. Level the refrigerator to ensure it sits firmly on the floor,
To level the refrigerator:
1. Remo_e the base grille.
2.Turn the leveling leg cloekavise to raise the cabinet or cmmtercloc_vise to lower the cabinet.
TURNLEGCLOCKWISETO
RAISE CABINET CORNER.
TURN LEG COUNTER-
CLOCKWISE TO LOWER
CABINET CORNER.
3.If the floor is not level and it is necessary to raise the back of the cabinet, roll the back wheels onto a piece of pl}avood or other shim material.
4.To replace the base grille, center the clips in the cut- out areas and push in until it snaps into place.
Connecting the Appliance
WAliNIN(7,: This appliance is designed to operate on a nominal 115 volt, 15 amp, 60 cycle line. There
should be a separate, grounded circuit serving this appliance only. Do not use an extension cord.
This appliance is equipped with a
receptacle is encountered, it is the personal responsibility and obligation of the customer to have it replaced with a properly grounded
ENERGYSAVINGTIPS
1.Locate the refrigerator away from heat sources such as the range, dishwaslmr, heat _ents and direct sun- light.
2.Keep the freezer filll to near capacity so less cold air x_dllescape dnring door openings (see page 5).
3. Let hot dishes cool sliglitly.
• V ' ,
4. Co er liquids.
5.Clean the refrigerator condenser coils once a },car, more often if yon have pets (see page 10).
6.Wipe moisture from the outside of containers before placing them in the refrigerator.
7.Avoid opening the doors too often.
PAGE 1