|
|
| INSTALLING RANGE HOOD |
|
| |||
|
|
|
| |||||
|
|
|
| |||||
|
| WARNING |
|
| 6. Strip 1/2" of insulation foam wires. Connect white to white, black | |||
|
|
| ||||||
| TURN OFF THE PROPER CIRCUIT AT THE SERVICE |
| to black, and green to prepared hole with green ground screw | |||||
| ENTRANCE BEFORE WIRING THIS RANGE HOOD. |
| provided. (FIG. 11) | |||||
1. Run electric wiring through hole drilled in wall or cabinet. Split |
| FIG. 11 | ||||||
| wiring for 6" and install proper connector for type of wire used. |
| ||||||
| (FIG. 9) |
|
|
|
| |||
|
|
|
|
| ||||
| FIG. 9 |
|
|
|
| |||
|
|
|
|
|
|
|
|
|
2.Position hood so that:
a.) Wiring is routed through knockout opening. (FIG. 10)
b.) Large part of keyhole slots fit over hood mounting screws. (FIG. 10)
c.) Damper/duct connector slides into ductwork. (UXT3030AA, UXT3036AA, UXT4030AA, and UXT4036AA.
FIG. 10 | 7. | Replace wiring box cover and screw. Make sure that all wiring is |
|
| safely contained inside. |
| 8. | Install light (75 Watt maximum) For easier installation, squeeze |
|
| plastic lens and remove it from hood. Remember to reinstall |
|
| lens (FIG. 12) |
FIG. 12
3.Adjust hood so that hood front is flush with cabinet frame.
4.Tighten hood mounting screws firmly.
5.Fasten wiring to hood with proper electrical connector for type of wiring being used.
WARNING
ALL ELECTRICAL CONNECTIONS MUST BE IN
ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR
NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR
WITH METHODS OF INSTALLING ELECTRICAL WIRING,
SECURE THE SERVICES OF A QUALIFIED ELECTRICIAN.
9. Turn on power and check operation of fan and light. Make sure that damper operates freely.
5
