2
INSTALLATION INSTRUCTIONS

Tools and Parts

Gather the required tools and parts before starting installation. Read
and follow the instructions provided with any tools listed here.

Tools needed:

Parts supplied:

Remove parts package from the washer basket. Check that all
parts were included.

Parts needed:

Check local codes, electrical supply and venting, and read “Electrical
Requirements” and “Venting Requirements” before purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your washer/dryer. For further information, please reference the
“Assistance or Service” section of the Washer/Dryer User Instructions.

Alternate Parts

Your installation may require additional parts. For information on
ordering, please refer to the toll free phone numbers on the front
page of the Washer/Dryer User Instructions.
#2 Phillips and flat-blade
screwdriver
Adjustable wrench that
opens to 1" (25 mm) or 9⁄16"
open-end wrench (for
adjusting washer/dryer feet)
¼" nut driver or socket
wrench (recommended)
Wire stripper (for U.S.
only, direct wire
installations)
Caulking gun and
compound (for installing
new exhaust vent)
Level
Wood block (for leveling)
Ruler or measuring tape
Knife
Vent clamps
Pliers
Scissors
Tin snips (for new vent
installations)
A.Front leveling feet with nuts (2)
B.Shipping strap (not in parts bag.
See “Remove Shipping Strap”)
C.Drain hose
D.Silver double-wire hose clamp
A B C D
If You Have You Will Need to Buy
Laundry tub or
standpipe taller than
96" (2.4 m)
Sump pump system (if not already
available)
1" (25 mm) diameter
standpipe2" (51 mm) diameter to 1" (25 mm) diameter
standpipe adapter, Part Number 3363920
Overhead sewer Standard 20 gal. (76 L) 34" (864 mm) tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain Drain protector, Part Number 367031
Water faucets
beyond reach of fill
hoses
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008

Parts needed for washer (not provided):

Inlet hoses Flat washers
To order:
Call the dealer from whom you purchased your washer/dryer.
Call the toll-free number listed on the cover of the Washer/
Dryer User Instructions.
Visit the website listed on the cover of the Washer/Dryer
User Instructions.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Record hose installation or replacement dates for
future reference.