Maytag W10401504D Prepare Dishwasher, Option D, No waste disposer - with air gap, Tip Over Hazard

Option D, No waste disposer – with air gap

1.Connect rubber end of drain hose to

air gap and cut if needed. NOTE: Do not cut ribbed section.

2.Attach drain hose to air gap with

large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided).

3.Use a rubber hose (not provided)

with screw-type clamps (not provided) to connect from waste tee to air gap.

Prepare Dishwasher

WARNING

Tip Over Hazard

Do not use dishwasher until completely installed. Do not push down on open door.

Doing so can result in serious injury or cuts.

WARNING

Excessive Weight Hazard

Use two or more people to move and install dishwasher.

Failure to do so can result in back or other injury.

Remove and discard the foam blocks located above the front legs on each side of the dishwasher. The blocks cover the rope/link pulleys on the dishwasher.

Helpful Tip: Place cardboard under dishwasher until installed in cabinet opening to avoid damaging floor covering. Do not use door panel as a worktable without first covering with a towel to avoid scratching the door panel.

11