Maytag W10562338A - SP Wrinkle Prevent/Wrinkle Prevent with Steam, On some models, Drum Light

5 CYCLE OPTIONS	6	LED DISPLAY AND SETTINGS BUTTONS
Use these buttons to select available options for your		When you select a cycle, its default settings will light up
dryer. Not all cycles and options are available on all		and the Estimated Time Remaining (for Sensor Cycles) or
models.		actual time remaining (for Timed Cycles) will be displayed.
Wrinkle Prevent/Wrinkle Prevent with Steam		Use the buttons along the bottom of the display to adjust
		settings. See “Cycle Guide” for available settings on each
(on some models)
		cycle. Not all settings are available with all cycles.
If you will be unable to remove a load immediately,
press Wrinkle Prevent to add up to 150 minutes of
periodic tumbling to help reduce wrinkling. On models
with Wrinkle Prevent with Steam, a short steam cycle is
added after 60 minutes to help smooth out wrinkles.
Drum Light
Press to turn the drum light on or off. The light will
also turn on when the door is open, and turn off
automatically after about 5 minutes.
Damp Dry Signal
When selected, a signal will sound during the drying
cycle when the load is damp but not completely dry.
This will allow you to take clothes out of the load that
do not need to dry completely. This option is available
on Heavy Duty, Normal, Denim, Bulky, Wrinkle		Steam model shown
Control, Sheets, Active Wear, Towels and Delicate
cycles.		Airflow
NOTE: The Damp Dry signal defaults to “ON” when
		This indicator will show the status of airflow through
using the Bulky cycle.		the dryer during Sensor cycles. The Detecting light comes
Cycle Signal		on during the sensing phase at the beginning of cycle.
		The Good light will come on if no major vent blockage is
Use this button to turn the signal indicating the
		detected. The Check Vent light will come on if a blocked
end of a drying cycle on or off, or to adjust the
		vent or low airflow issue is detected. For more information
volume of the signal.
		on maintaining good airflow, see “Check Your Vent System
NOTE: You may also turn off the tones that sound
		for Good Airflow”. The Airflow sensing feature is available
when a button is pressed. Press and hold the Cycle		for Sensor cycles only.
Signal button for about three seconds to turn button		NOTE: If there are other error issues during a cycle, the
sounds on or off.
		Airflow indicator will not light up. See “Dryer Displaying
Reduce Static (on some models)		Code Message” in “Troubleshooting”section.
Press to add the Reduce Static option to selected		Steam (on some models)
Sensor cycles (see Cycle Guide). The dryer will
		This indicator will light when the Steam function is active.
automatically tumble, pause, and introduce a small
		NOTE: Steam options are not available on all models
amount of moisture into the load to help reduce static.
This option adds approximately 8 minutes to the total		or on all cycles.
cycle time.		Done
Steam Boost (on some models)		This will indicate that the selected cycle has ended and
Steam Boost adds steam to the end of the Heavy Duty,		the load may be removed from the dryer. If the Wrinkle
Bulky, Normal, Sheets, Towels, or Denim cycle to help		Prevent option has been selected, the dryer may continue
smooth wrinkles.		to tumble the load, even if the DONE indicator is lit.

Check Lint Screen

The Check Lint Screen indicator will light when the drying cycle is complete as a reminder to clean the lint screen.

Wrinkle Prevent

This indicator will light if the Wrinkle Prevent option

has been selected and is running. The dryer will continue to periodically tumble the load for up to 150 minutes (depending on model and selected settings) after the cycle has ended.

6