McCall Refrigeration MCCSTF48 Caster Installation, 2”, 3” and 5” Caster and Leg Mounting Detail

Compact Refrigerators and Freezers Service and Installation Manual

Caster Installation

1.Carefully place the unit on its back (see illustration at right).

2.Remove legs by unscrewing them in a counter clockwise direction.

3.Located on each end of the compressor channel are 4 hex head screws, for a total of 8 screws. Remove them. 8 additional screws are provided with your casters.

4.Place a locking plate caster over one of the front holes, matching the 4 mounting holes to the pre-drilled holes in the underside of the unit. Insert 4 hex head screws and tighten. Repeat with the other locking front casters.

5.Repeat step 4 with the non-locking casters in the rear of the unit.

6.Carefully lift the unit upright.

After installing casters, the unit must stand upright for twenty-four (24) hours before being powered up to assure oil return to the compressor

WARNING sump.

Plate Casters

W/Locks

Plate Casters

W/O Locks

#14 x .75" Hex Head

Screws #932-1116

2”, 3” and 5” Caster and Leg Mounting Detail

A universal bolt hole pattern is provided on the bottom of the cabinet. It will accommodate any leg or caster. Simply line up the plate holes with the corresponding cabinet holes.

2.38”

1.75”

0.94”

3.40”2.82”

2.14”

NOTE:	NOTE:	NOTE:
If hole pattern on caster/	If hole pattern on caster/leg	If hole pattern on caster/leg
leg matches the one above	matches the one above mount	matches the one above mount
mount in outer set of holes.	in middle set of holes.	in inner set of holes.
6” Leg - 3234569	3” Caster - 3234024	2” Caster - 3234148
	5” Caster - 3234161

4 For customer service, call (888) 732-2446 Fax (800) 669-0619, www.mccallrefrigeration.com