Save These Instructions, Assembly Instructions

2 - SAFETY PRECAUTIONS

3 - ASSEMBLY INSTRUCTIONS

15.The operation of any tool can result in foreign objects being thrown into your eyes, which can

result in severe eye damage. Before operating power tool, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We rec- ommend wide Vision Safety Mask for use over eye- glasses or standard safety glasses with side shields.

2-4. INTERNATIONAL SYMBOLS

1.Never place hands into discharge chute as serious injury will occur (Figure 2-1).

2.Use of these personal safety items is highly recom- mended to reduce the risk of accidental injury (Figure 2-2).

3-1. CONNECTING WHEEL ASSEMBLY

NOTE: Locate small bag of hardware containing two Allen hex screws, two large flat washers, two small flat washers and two split pins.

1. Place one wheel on the axle followed by a large flat

washer. Secure by inserting a split pin through the

hole in the end of the axle, bend the ends over using

pliers. See Figure 3-1A.

3-2. ATTACHING WHEEL ASSEMBLY TO UNIT

1.	Remove feeder tube by loosening & spring loaded
	knobs. Figure 3-2A.
2.	Lay motor assembly down on flat surface with plug
	facing down.
3.	Place a 2x4 under bottom of motor to obtain correct

2-3. EXPLANATION OF NOTE, WARNING, AND WARRANTY SYMBOL

1.A NOTE is used to convey additional information, or highlight a particular explanation, or to expand a instruction.

2.A WARNING identifies a procedure which, if not undertaken or if improperly done, can result in a seri- ous personal injury or damage to the unit and/or both.

3.(WARRANTY SYMBOL) serves notice that

unless instructions or procedures are followed, any damage will void the warranty and repairs will be at owner’s expense. Service other than user mainte- nance should be performed by a McCulloch Authorized Service Center. Damage or conditions caused BY improper maintenance practices which render this product inoperable will void the manufac- turer’s warranty.

4.FOR WARRANTY OR SERVICE contact the nearest McCulloch Authorized Service Center.

SAVE THESE

INSTRUCTIONS

2.	Press wheel cover on wheel.
3.	Position the axle assembly on the inside of the sup-
	port tube as shown in Figure 3-1B, aligning the hole in
	the axle with the hole in the support. Place a lock-
	washer and small flat washer on the Allen hex screw
	and guide them up through the hole in support tube
	and into the hole in the axle. The flat washer should be
	next to the axle.
4.	Assemble the other tube support to the other end of
	the axle in the same manner.
5.	Attach the second wheel to the axle using the same
	method as described in step 1.

Axle	Flat Washer
	and Split Pin

	angle to attach wheel kit.
4.	Wheels should be toward floor (same as plug).
5.	Align top of support tubes (2 holes) with 2 holes in
	motor housing. Using hardware (fiat washers of lock
	washers, and 4 hex bolts attach support tubes to
	motor housing & tighten.
6.	Stand unit of and reattach feeder. Tube by tightening 3
	spring loaded knobs.